![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On Aug 15, 7:38 pm, Paul Cordell wrote:
On Aug 15, 3:11 pm, " wrote: On Aug 15, 12:52 pm, Paul Cordell wrote: I had 1 depart in Flight and need a replacement. Rumor has it that the factory no longer stocks this style and they are currently on vacation http://www.gliderforum.com/photos/sh...umid=5¤tpos=35 Dont tell me the plastic you installed on the underside blocked the vent and the thing shot out like a champagne cork at altitude ![]() Regards Al Nope! The caps fit loose and after I had cleaned off the old tape residue, I forgot to retape...... We heard it came loose in a barrel roll through the finish ;-) Hope to see you at New Castle ! Best Regards, Dave "YO" |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
FS: Schempp-Hirth Discus A | Tim Hanke | Soaring | 0 | February 19th 06 02:16 PM |
Schempp-Hirth | Mel Dawson | Soaring | 0 | February 15th 06 04:08 PM |
Schempp-Hirth water Ballast Cap vent Mod | Paul M. Cordell | Soaring | 11 | May 25th 05 10:33 PM |
Schempp Hirth or its Representatives... | Chris OCallaghan | Soaring | 11 | September 23rd 03 09:28 AM |
Excellent follow-up by Schempp-Hirth! | ventus2ct (Ruud Holswilder) | Soaring | 2 | August 9th 03 09:19 PM |