|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
August 25th 07, 07:01 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Reaming
wrote The best book to explain all this is "Mechanical Engineering Design" by Joseph Edward Shigley, Professor at the University of Michigan, chapter 8, "Design of Screws, Fasteners, and Connections". It is THE most widely used text on the subject in the top engineering schools of the country, and has been for many years. Hell, that explains it, when I see what your source material is from! BFG -- Jim in NC Ohio State University Alum, and former 5 year marching band member. Go Bucks! 
|
|
#2
August 25th 07, 07:17 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Reaming
Hell, that explains it, when I see what your source material is from! BFG -- Jim in NC Ohio State University Alum, and former 5 year marching band member. Go Bucks! Oh, and I forgot to add, "Muck Fichigan! "
|
|
#3
August 25th 07, 11:50 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Reaming
On Aug 25, 1:17 pm, "Morgans" wrote:
Hell, that explains it, when I see what your source material is from! BFG -- Jim in NC Ohio State University Alum, and former 5 year marching band member. Go Bucks! Oh, and I forgot to add, "Muck Fichigan! " I didn't attend Michigan, its just a great book  .Bud
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reaming needed on aft wing attach point. | Boelkowj | Home Built | 0 | November 7th 03 01:30 AM |
Hybrid Mode
