|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 19th 07, 09:11 PM
posted to rec.aviation.owning
|
|||
|
|||
Excessive valve clearance cause low power?
Fly fly at Tulsaconnect.com wrote:
: New camhafts been measured at .357 intake and .358 exhaust lift. At .050 : valve opening. Thank you. That's what I measured on all of the lobes of mine (at least to within the 0.001-0.003 accuracy I could measure with my dial indicator). -Cory -- ************************************************** *********************** * Cory Papenfuss, Ph.D., PPSEL-IA * * Electrical Engineering * * Virginia Polytechnic Institute and State University * ************************************************** *********************** 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ball Valve,Needle Valve,Snubber,Gauge Cock Sale on good price | valvetom | Piloting | 0 | November 28th 06 02:32 AM |
| Brass Ball Valve,Gas Valve,Needle Valve,Angle Valve,Hose Bibcock Sale on good price | valvetom | Piloting | 0 | November 28th 06 02:25 AM |
| Power setting table and best economy/best power... | xerj | Piloting | 29 | October 20th 05 02:44 AM |
| sticky valve or | Dick | Home Built | 18 | May 25th 05 07:50 PM |
| sticky valve or | Dick | Owning | 18 | May 25th 05 07:50 PM |
Hybrid Mode
