|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 30th 03, 12:27 PM
|
|||
|
|||
OR HERE http://bidasst.bizland.com/rv8wbp.htm Jerry ++++++++++++++++++++++++++++++++++++ Hmmm. These are two dramatically DIFFERENT programs. The one above is generic and takes W-O-R-K to use. g OTOH... The custom *RV* CG program that can be had below requires almost none since the ARM and weights are already plugged in. PLUS it allows one to go from scratch, too. Pretty neat. Thanx, Barnyard BOb 
|
|
#2
September 30th 03, 01:20 PM
|
|||
|
|||
|
Did not say I was handing to you on a silver platter. :-)
Jerry Barnyard BOb -- wrote: OR HERE http://bidasst.bizland.com/rv8wbp.htm Jerry ++++++++++++++++++++++++++++++++++++ Hmmm. These are two dramatically DIFFERENT programs. The one above is generic and takes W-O-R-K to use. g OTOH... The custom *RV* CG program that can be had below requires almost none since the ARM and weights are already plugged in. PLUS it allows one to go from scratch, too. Pretty neat. Thanx, Barnyard BOb
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| bulding a kitplane maybe Van's RV9A --- a good idea ????? | Flightdeck | Home Built | 10 | September 9th 03 07:20 PM |
| Awesome, free anti-virus program | Ken Sandyeggo | Home Built | 23 | September 4th 03 07:29 PM |
| Vans RV4 or RV6 wanted | Joe | Home Built | 0 | August 17th 03 01:02 PM |
Hybrid Mode
