![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On May 6, 8:00*pm, Gezellig wrote:
explained on 5/5/2008 : * * * * * Seven Learning Factors taught to new instructors. The first one is Primacy, which says that first iimpressions are the strongest. The first few taxis with the hand on the leg will establish a lifelong habit. * * * *We teach controls for wind right off. Student needs to get it right the first time. Da, this is what I found out after a few more taxis/TO. * * * * Wingflap's suggestion of putting pressure on both rudder pedals is another bad idea. Nervous students already stand on them, and they'll only put more pressure on them if told to do so. I see worn-out rudder control system parts from just that, since in most lightplanes that tension is transmitted down both cables to the rudder horn itself. Rudder hinges, clevis bolts and their holes, pulleys and cables, rudder bars and pedals, all wear much faster than usual if they're under constant tension. And the pushback on the seat wears all that stuff out, too. Takes time, but it does wear. I think WingFlaps meant well but my CFI gave me the once over when I suggested Wingflaps ideas. Your CFI obviously went to the Dan school of flying. That's a pity because correct rudder bar technique involves putting -light- pressure on the rudder bar as I described. As stated in the FAA flight guide (http://www.faa.gov/library/manuals/a...andbook/media/ faa-h-8083-3a-2of7.pdf): "When using the rudder pedals, pressure should be applied smoothly and evenly by pressing with the ball of one foot. Since the rudder pedals are interconnected, and act in opposite directions, when pressure is applied to one pedal, pressure on the other must be relaxed proportionately. When the rudder pedal must be moved significantly, heavy pressure changes should be made by applying the pressure with the ball of the foot while the heels slide along the cockpit floor. Remember, the ball of each foot must rest comfortably on the rudder pedals so that even slight pressure changes can be felt." I have found that without maintaining light pressure to keep your feet in contact with the bar you can't hold a straight course -especially while instrument flying. Just one more point, if you are worried about aircraft wear, constantly tapping pedals is much worse than maintaining smooth light pressure... Hope this helps, and no it's not a troll.. Cheers |
#2
|
|||
|
|||
![]() Hope this helps, and no it's not a troll.. Cheers Na, as far as I'm concerned, Wingflaps is not a troll. But you have to hand it to him, he keeps his eyes open for them. I'm sure the trolls will be next. Lou |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Training | [email protected] | Instrument Flight Rules | 1 | August 12th 05 02:04 PM |
Training | [email protected] | Aviation Marketplace | 0 | August 11th 05 02:10 AM |
Training | Ruski | Soaring | 4 | August 1st 05 11:48 PM |
Training Q - Is this appropriate | Jules | Instrument Flight Rules | 1 | August 6th 04 05:57 AM |
Yak 52 Training | gpa | Aerobatics | 0 | November 10th 03 06:15 AM |