|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
June 24th 08, 02:22 AM
posted to rec.aviation.marketplace,rec.aviation.homebuilt
|
|||
|
|||
Aeronca 11AC Chief Project FS
In article ,
Jay Maynard wrote: On 2008-06-23, Victor Bravo wrote: You can walk up to a CH601 and move the tip of the horizontal stabilizer fore and aft a very disturbing amount (I have on three separate aircraft). Several years ago that was discovered on the Cherokee Six that I fly. The airplane was immediately grounded and put into maintenance to have the bushings replaced. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aeronca Chief Gear Alignment? | Richard Lamb | Restoration | 1 | July 8th 03 06:04 PM |
Hybrid Mode
