|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 6th 08, 07:37 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Primary Glider Drawings
Perhaps nothing except the basic fundamental understanding of WHAT SNIP
MEANS. Veeduber What would it take to convert a primary into a basic soaring machine (35+ to 1)?. 
|
|
#2
October 8th 08, 01:03 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
|
Primary Glider Drawings
On Sun, 5 Oct 2008 23:37:22 -0700, "RST Engineering"
wrote: Perhaps nothing except the basic fundamental understanding of WHAT SNIP MEANS. Veeduber What would it take to convert a primary into a basic soaring machine (35+ to 1)?. ************************************ RST Know what snip means but don't have the ability like you to know what was said back in thread without reading it current. Sure wish I had that ability and I'd know how election will come out. Big John
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PRIMARY GLIDER DRAWINGS(2) | [email protected] | Home Built | 0 | October 4th 08 05:48 AM |
| Primary Glider Recall | [email protected] | Home Built | 2 | October 3rd 08 08:19 PM |
| PRIMARY GLIDERS | [email protected] | Home Built | 2 | September 21st 08 08:40 PM |
| glider cutaway drawings | James D'Andrea | Soaring | 2 | April 12th 07 03:31 AM |
| Primary nav source | Wizard of Draws | Instrument Flight Rules | 17 | December 21st 05 07:11 AM |
Hybrid Mode
