![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On Dec 2, 5:28*pm, " wrote:
On Dec 1, 5:27*pm, Bob Kuykendall wrote: The thing I'm curious about is the wing profile. --------------------------------------------------------------------------- ------------ Nothing especially new there. *It is a faceted surface. *Lots of 'interesting' characteristics with regard to lift & drag. You mean not much lift for drag -right? But what really makes my hair stand on end is the empty weight. *A tad on the chubby side, in my opinion. What did you expect from tarps for wing coverings? Cheers |
#2
|
|||
|
|||
![]() You mean not much lift for drag -right? -------------------------------------------------------------------- Dear MC, I wasn't referring specifically to this aircraft (too little data) but to faceted wing surfaces in general. From what I CAN see ( at least on the lower wing ), the characteristic transition surface(s) needed to make the faceted portion work, appears to be missing. -R.S.Hoover |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
LS3A Wing Profile Data | Robert Fidler | Soaring | 14 | October 27th 08 09:59 PM |
EAA Biplane Project CHEAP $500 | Victor Bravo | Home Built | 1 | March 12th 08 08:02 PM |
Any-1 remember biplane folding upper wing at show? | On-Condition | Home Built | 2 | September 21st 05 04:06 AM |
ASW27 wing profile templates | basils27 | Soaring | 0 | June 29th 05 11:46 AM |
Biplane wing dihedral | vincent p. norris | General Aviation | 20 | June 18th 05 02:58 AM |