|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
December 5th 08, 01:54 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Interesting biplane project... look at the wing profile
You mean not much lift for drag -right? -------------------------------------------------------------------- Dear MC, I wasn't referring specifically to this aircraft (too little data) but to faceted wing surfaces in general. From what I CAN see ( at least on the lower wing ), the characteristic transition surface(s) needed to make the faceted portion work, appears to be missing. -R.S.Hoover 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LS3A Wing Profile Data | Robert Fidler | Soaring | 14 | October 27th 08 09:59 PM |
| EAA Biplane Project CHEAP $500 | Victor Bravo | Home Built | 1 | March 12th 08 08:02 PM |
| Any-1 remember biplane folding upper wing at show? | On-Condition | Home Built | 2 | September 21st 05 04:06 AM |
| ASW27 wing profile templates | basils27 | Soaring | 0 | June 29th 05 11:46 AM |
| Biplane wing dihedral | vincent p. norris | General Aviation | 20 | June 18th 05 02:58 AM |
Hybrid Mode
