Torque Wrench Calibration

wrote:
I was getting ready to install a replacement manifold on the old Mercury
and it occurred to me I ought to be pretty sure my torque wrench didn't
strip the aluminum threads. The Snap On dial wrench hasn't been
recalibrated for 30 years and the Craftsman torsion bar wrench is too
clumsy to get to some of the bolts. I was kicking it around and I came
up with using the torsion bar wrench on a bicycle axle nut and then
putting the dial wrench on it to see if the reading matched. It did.
Then, I went ahead and checked the Craftsman clicker wrench of the same
vintage and recalibrating, and it came up with a match also. Then I did
the torquing with the dial wrench and cross checked it with the torsion
bar wrench, with all good readings. So, I'm just going to call them
calibrated.
Andy
Phoenix

Dats de way I does it---but as a cross check--& I only have one 3/4"
torque wrench--I welded an old 3/4 socket about eye high to the side of
my gantry truck engine hoist. plug the wrench in horizontal, attach a
5 gallon bucket to the mid point of the handle, & throw in known
weights till the wrench clicks, or dial reads correctly.--don't forget
weight of bucket G Jerry