![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
"brian whatcott" wrote in message
... Stealth Pilot wrote: There is, in fact, an extension on the 150M, and possibly the 150L and later 150F models; but I have never seen the manuals for those. I don't recall whether ther extension was 2 inches or 3 inches. I believe that the extension was concurrent with the change to the Clark-Y propeller and a revised nosebowl/cowl. Peter ok that would post date the manual I have. No extension on 63-69 models in the '70 parts catalog. Brian W That's true. It was on the 1977 model (150M) and may have been on the 150L which was build in 1976 and possibly 1975--I don't have the information currently available. The prop extesion was part of a long series of improvements that gradually brought the stated cruise speed back up to what is had been on the earliest models--despite the wider cabin and "notch back" rear window. I have trouble thinking of the 152 and later 150 and wide bodies; but this really is what they were! Peter |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tray connector for Narco AT50a part number | [email protected] | Owning | 2 | February 1st 06 03:01 AM |
wanted-Melling part number 29840 solid lifters-Chevy V-8 | [email protected] | Home Built | 1 | March 9th 05 03:52 AM |
Pitts Number 1 registration number | Mirco | Aerobatics | 3 | December 4th 04 11:50 AM |
Need part number for Icom antenna jack | Roy Smith | Owning | 2 | March 17th 04 09:59 PM |