|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
December 11th 09, 02:12 AM
posted to rec.aviation.soaring
|
|||
|
|||
DG505, DG500 Spoiler box does not drain and freezes
Darryl Ramm wrote:
The boxes are sealed but the lower floor of the box usually is or touches the bottom wing skin so if you really wanted to you could drill a hole right there through the lower skin. Your A&P may have a different idea. But why? /snip/ Darryl Drains are fitted to powered airframes because it takes relatively little trapped water to give a very nasty aft pitching (or rolling) moment... Brian W 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| using less spoiler just before the flare??? | Gary Emerson | Soaring | 16 | October 29th 07 01:08 PM |
| Landing with one spoiler | [email protected] | Soaring | 82 | October 7th 05 12:58 AM |
| DG500 AD notes | Sailplane Mechanic | Soaring | 2 | August 27th 04 05:35 PM |
| Spoiler placement and design. | B2431 | Home Built | 9 | November 11th 03 04:02 PM |
| FS2002 freezes up only with Hardeware Acceleration Engaged! | Peter | Simulators | 2 | November 7th 03 08:30 PM |
Hybrid Mode
