![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On Apr 5, 12:31*pm, johngalloway wrote:
On 5 Apr, 16:32, T8 wrote: On Apr 5, 11:22*am, JS wrote: You're right, it's about 100 hours. * It's just another thing to deal with at Annual time. For many people using "clear log" at Annual is sufficient to keep the gremlins away. But if you fly a lot, that isn't enough. Perhaps stick a post-it note in the logbook to remind you of when the next "clear log" is due... * SPOT batteries should get changed at each Annual too. I put 200 hours on the 2 Lithium AAs (version 1) with no problem, but doubt I'd push it another year. * At the bottom is a way to make and test a log without flying, to check 302 security. Jim Clearing the flight log memory in a 302 or 302A This may help reduce flight log security issues on future flights. Important Note: This will erase all flight logs in memory! 1. * * *Connect the 302 or 302A to a PC using the RS-232 serial cable that was supplied with the 302. 2. * * *Power the 302 or 302A with 12 volts and make sure the unit is turned-on. *The GPS antenna does not need to be connected. 3. * * *Run a terminal emulator program on the PC. *A good one to use is HyperTerminal. *It is included with most versions of Windows. *To access it go to: o * * * Start Menu / All Programs / Accessories / Communications / HyperTerminal 4. * * *In the "New Connections" window enter "302" for the Connection Name and then click the OK button. 5. * * *In the "Connect To" window, set the "Connect using" parameter to match the desired communications port. *This is the port which the RS-232 serial cable is connecting with. *It is usually COM1, COM2, etc. and will vary from PC to PC. *Then click the OK button. 6. * * *In the "COMx Properties" window set the parameters as specified below and then click the OK button: o * * * Baud Rate: 4800 o * * * Data Bits: 8 o * * * Parity: None o * * * Stop Bits: 1 o * * * Flow Control: None 7. * * *You should now see GPS data sentences appearing in the HyperTerminal window. 8. * * *Hold the "Ctrl" button on your computer's keyboard and hit the "c" button (Ctrl-c). *The flow of GPS data should stop. 9. * * *At the "cmd" prompt type: "clear log" and hit the Enter key. *I don't think there is any acknowledgement from the 302 other than that the "cmd" prompt reappears. Checking the 302 logger with HyperTerminal: * Connect as above Ctrl C Type START Allow it to log 10 minutes. Type STOP * Then download the log with the CAI 302 utility and check security.. Thanks JS. *Somehow, I though the point of the memory upgrade was to avoid having to do this... -T8 Some time ago I had security fail with a 302ACFR *that hadn't been prevented by prior regular clearing of the flight log but did go away when I sent the unit back to Cambridge for the Flash upgrade and re- sealing. However another possible cause is a flat security memory backup battery. *That's what caused my most recent security fail - this time with a 302 DDV - and when I took advice (identity withheld for obvious reasons) about having the flash upgrade done to the unit at the same time as the battery replacement/re-seal I was told that: "the original chips used became obsolete so an almost direct equivalent has been cobbled onto the original board in the last 2 years production. *There were then some timing issues, but Phil Schlosser did some consultation and sorted out the problem. *It turned out that the timing had always been marginal, so there was a software update that makes both old and new memory chips more reliable. *The original ones do not need the odd hard-wired jumpers to make them work on the pcb. *There is no difference in functionality between the original and replacement memories, and it is believed by the design team that the ones the unit was designed around are more reliable. (The new ones have in principle more memory, but there is not the control available to use it)." I can't vouch this but I didn't get the flash changed on the second unit. John Galloway I had CAI put a new battery in my unit when it was returned for the upgrade. That's an "interesting" story. If true... I'm just glad those guys weren't building wing spars for Schleicher when my ship was built. -T8 |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rotax 582 rod big end failures | Beaver Shaver | Home Built | 2 | October 2nd 06 02:43 AM |
MH EDS failures | Philip Plane | Soaring | 6 | December 16th 05 12:37 AM |
Colibri failures? | [email protected] | Soaring | 3 | April 15th 05 12:30 AM |
Colibri Failures. | Stan Kochanowski | Soaring | 2 | April 6th 05 01:00 PM |
Colibri Failures. | Stan Kochanowski | Soaring | 1 | April 6th 05 12:24 PM |