![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On Sep 10, 3:52*am, Bill D wrote:
While designing your hangar dolly, take a look at the clever jackable fuselage trailer dollies used on fixed gear 2-seaters. *Replacing the trailer dolly's straight-rolling wheels with casters would make a very easy to use hangar dolly since you wouldn't have to push the glider up onto a freely castering dolly. Some pics I took of the one that came with our DG1000 trailer. http://www.flickr.com/photos/bruceho...00clubtrolley/ |
#2
|
|||
|
|||
![]()
On Sep 9, 4:35*pm, Bruce Hoult wrote:
On Sep 10, 3:52*am, Bill D wrote: While designing your hangar dolly, take a look at the clever jackable fuselage trailer dollies used on fixed gear 2-seaters. *Replacing the trailer dolly's straight-rolling wheels with casters would make a very easy to use hangar dolly since you wouldn't have to push the glider up onto a freely castering dolly. Some pics I took of the one that came with our DG1000 trailer. http://www.flickr.com/photos/bruceho...00clubtrolley/ thanks for all the suggestions and link guys...............much appreciated. ended up with a Harbor Fraud unit, 6" semi-solid tire, under $20.00. also ordered a bunch of stuff from M&C for the wing wheel dolly, the nose capture bowl and the control system circuit. Brad |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
ASK-21 fuselage dolly | bildan | Soaring | 8 | August 1st 10 05:43 PM |
LS4 tail dolly | Leigh | Soaring | 0 | May 30th 08 02:02 AM |
WTB: used tail dolly | David Campbell | Soaring | 5 | April 17th 06 03:19 PM |
assembly dolly | Udo Rumpf | Soaring | 0 | April 29th 05 04:17 PM |
L-23 tail dolly | Mark Zivley | Soaring | 1 | November 27th 04 11:16 AM |