|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
August 27th 12, 07:10 AM
posted to rec.aviation.soaring
|
|||
|
|||
Contest Number on PowerFlarm (US)??
On Sunday, August 26, 2012 6:10:13 PM UTC-7, Bob Gibbons wrote:
Now, if I could only figure out where to put the flarmnet file for it to read into my Brick... The Brick doesn't care about flarmnet. You can't load the flarmnet file to the brick. It is the display device that uses the flarmnet file. I have posted instructions on loading the Butterfly display with flarmnet in the flarmnet thread. The documentation seems to suggest that loading the flarmnet file to the display from the brick usb port will be supported in the future. The Butterfly remote display is also plug and play compatible with the portable and can provide flarmnet support for that device. BTW anyone with a Windows PC has an Octal to Hex converter. Just open the supplied calculator in scientific view. Select Oct, enter the octal ICAO address, press HEX, read the HEX address. Andy, GY 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| contest number question | Gary Emerson | Soaring | 22 | February 9th 18 04:15 PM |
| PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 25th 12 11:58 PM |
| PowerFLARM | Paul Remde | Soaring | 9 | November 6th 10 04:30 AM |
| Contest Number Removal | Roy Bourgeois | Soaring | 4 | March 31st 07 09:12 PM |
| Pitts Number 1 registration number | Mirco | Aerobatics | 3 | December 4th 04 11:50 AM |
Hybrid Mode
