|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
June 1st 13, 03:29 PM
posted to rec.aviation.soaring
|
|||
|
|||
PowerFLARM 3.0 and TIS
An update for anyone interested in using the PF TIS output -
I reduced my ADS-B range and altitude to more reasonable flight numbers (5 miles, 2,000ft. This stopped distant ADS-B targets taking priority over local non-directional targets on the 396 TIS display. Of course I also lost the display of the these distant target of the PF display. Given the restrictions of the TIS protocol it would be useful if the TIS data range and altitude settings could be set independent of the local display settings. Andy 
|
|
#2
June 7th 13, 12:00 AM
posted to rec.aviation.soaring
|
|||
|
|||
|
PowerFLARM 3.0 and TIS
Andy,
Given the restrictions of the TIS protocol it would be useful if the TIS data range and altitude settings could be set independent of the local display settings. I see your point. But it also adds more complexity to an already pretty complex system... Best --Gerhard
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PowerFLARM 2.71...WTF? | [email protected] | Soaring | 40 | May 2nd 13 03:32 AM |
| PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 25th 12 11:58 PM |
| PowerFLARM News | Paul Remde | Soaring | 3 | January 10th 12 03:26 AM |
| PowerFLARM | Paul Remde | Soaring | 9 | November 6th 10 04:30 AM |
| PowerFLARM | Greg Arnold[_2_] | Soaring | 6 | November 2nd 10 09:32 AM |
Hybrid Mode
