![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Pesky mountains ruin the horizon so I can't use the screws. Maybe I should
move to Kansas. Steve...? "Ramy" wrote in message ... One thing special about 45 degrees is that it is the only angle you can really measure in flight without artificial horizon. If the horizon is aligned with your instrument screws you are banked 45 degrees. You will often be surprised how steeper it is then you thought. Ramy |
#2
|
|||
|
|||
![]()
On Monday, October 7, 2013 11:19:01 AM UTC-5, Dan Marotta wrote:
Pesky mountains ruin the horizon so I can't use the screws. Maybe I should move to Kansas. Steve...? Stick with New Mexico and the uncertainty of your bank angle. |
#3
|
|||
|
|||
![]()
On Monday, October 7, 2013 12:40:08 PM UTC-4, Steve Leonard wrote:
On Monday, October 7, 2013 11:19:01 AM UTC-5, Dan Marotta wrote: Pesky mountains ruin the horizon so I can't use the screws. Maybe I should move to Kansas. Steve...? Stick with New Mexico and the uncertainty of your bank angle. Just send him a copy of "Condor" and a plastic joystick. That way he can be all trained up for when he eventually visits the flat lands. -Evan (still cleaning that red stuff out of my trailer) Ludeman / T8 |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
60 degree Mopar V6 for homebuilt? | RapidRonnie | Home Built | 17 | February 9th 07 04:12 AM |
90 degree locking pliers? | B. Jensen | Home Built | 8 | October 3rd 05 06:50 PM |
37 degree fitting | Ernest Christley | Home Built | 8 | June 17th 04 03:29 AM |
90 Degree turn while slipping | ISoar | Soaring | 40 | February 14th 04 10:49 AM |
37 degree flare, 1/8" stainless | Richard Riley | Home Built | 8 | August 29th 03 04:21 AM |