Does anyone use a tug tow hook that releases automatically whenglider kites?

At 16:41 18 February 2014, C-FFKQ 42 wrote:
On Tuesday, 18 February 2014 11:25:24 UTC-5, wrote:
On Tuesday, February 18, 2014 7:17:16 AM UTC-6, Don Johnstone wrote:
=20
It occurred to me that attaching the tow rope to the tug near the
center
=
of gravity (top of turtle deck on a Pawnee for example) would make kiting
a=
non-event. That's how all the RC gliders are towed since you cannot
contr=
ol the position of the glider really well in relation to the towplane
while=
standing on the ground. Interference of the tow rope with rudder and
elev=
ator does not seem to be a problem for RC fliers.


Um... wouldn't that cause a great risk of fouling the tail feathers of
the
=
tug? No more "boxing the wash".

OK here is a whacky idea. A V shaped boom with the point to the rear of the
rudder, the release mounted at this point. The two front points mounted to
a pivot, through the fuselage above the wing, near the CoG. The V
arrangement can pivot up, but not down. The space between the arms has to
be sufficient to allow full rudder. Would only work for low wing
monoplanes.

On Tuesday, February 18, 2014 1:50:52 PM UTC-7, Don Johnstone wrote:

OK here is a whacky idea. A V shaped boom with the point to the rear of the

rudder, the release mounted at this point. The two front points mounted to

a pivot, through the fuselage above the wing, near the CoG. The V

arrangement can pivot up, but not down. The space between the arms has to

be sufficient to allow full rudder. Would only work for low wing

monoplanes.

Well as long as were are drawing on envelopes, how about a bridle attached to each wingtip of the towplane, with the towhook at the apex of the bridle, able to slide side to side (to prevent rudder stalls) while the bridle pivots up during kiting so the force just pulls the towplane higher! To drop the glider, release one end of the bridle and the towhook just slips off.

Or just teach the stupid glider pilot to fly the correct tow position!

Of course, a good winch solves this problem nicely....

Kirk

On Tuesday, February 18, 2014 6:56:56 PM UTC-5, kirk.stant wrote:
On Tuesday, February 18, 2014 1:50:52 PM UTC-7, Don Johnstone wrote: OK here is a whacky idea. A V shaped boom with the point to the rear of the rudder, the release mounted at this point. The two front points mounted to a pivot, through the fuselage above the wing, near the CoG. The V arrangement can pivot up, but not down. The space between the arms has to be sufficient to allow full rudder. Would only work for low wing monoplanes. Well as long as were are drawing on envelopes, how about a bridle attached to each wingtip of the towplane, with the towhook at the apex of the bridle, able to slide side to side (to prevent rudder stalls) while the bridle pivots up during kiting so the force just pulls the towplane higher! To drop the glider, release one end of the bridle and the towhook just slips off. Or just teach the stupid glider pilot to fly the correct tow position! Of course, a good winch solves this problem nicely.... Kirk

The Dragonfly towplane for hang & ultralite gliders uses a bridle attached above the top of the rudder and just below the bottom of the rudder, withbthe tow rope free to ride up and down on the bridle. Hang gliders sometimes get way out of shape, but the tug isn't affected.
UH