![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Aft fuselage statics work well but can be more susceptible to clogging when dumping water ballast in certain gliders with lower-surface-of-wing outlets (e.g., my old LS 3, in which owners installed a switch to pump pitot pressure through the lines to keep them clear). Probes are vulnerable to ground handling damage and in-flight spearing of geese. Your call as to which is more likely.
Chip Bearden ASW 24 "JB" U.S.A. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
PANEL PLUMBING | Travis Beach | Soaring | 3 | December 5th 07 10:00 PM |
PANEL PLUMBING | Travis Beach | Soaring | 0 | December 5th 07 02:16 PM |
PANEL PLUMBING | Travis Beach | Soaring | 0 | December 5th 07 02:16 PM |
fuel tank plumbing | pwm | Home Built | 18 | January 27th 05 04:54 AM |
Plumbing for a CAI 302 + Schuemann B-Box | Mark Grubb | Soaring | 1 | June 12th 04 03:39 PM |