Oudie to Cambridge

Hi
I have an Oudie connected to a GPS 25 and its works great.

Assuming the wiring is correct there is one big possible Gotcha
I am not sure anyone has mentioned.

The GPS 20 has to be sent a message by the Seeyou Mobile
on the 9 pin plug to command it to send out NMEA.

For Seeyou Mobile (SYM) to do this you have to have the SYM
set to both Cambridge GPS-NAV (in settings Hardware)
and the correct speed 4800 speed

It is very important that when you start Seeyou Mobile that
the Cambridge logger is powered up, otherwise it may
miss this message.

In the Terminal window you can manually send the command
to the Cambridge at the top of the window for test purposes
type NMEA then hit send.


So in summary assuming you have set up Seeyou mobile for
the Correct speed and Cambridge hardware.

I switch on the logger give it a minute to power up and
send waypoints to its square display. (which is a separate processor)

Then I start Seeyou mobile. Works every time :-)