|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
April 28th 15, 11:01 AM
posted to rec.aviation.soaring
|
|||
|
|||
Flarm Update - change to config file required?
On Saturday, April 18, 2015 at 8:24:39 AM UTC-4, Papa3 wrote:
Updated to V6 last week. Didn't see anything in the release notes or on the Flarm website about any requirements to create a new config file. Anyone else know differently? P3 One more fact--the USB thumb drive I used to load v6.xx did not have a config.file on it-I assumed that the flarm was already "configd". When I put the new config file on the thumb drive and inserted it, turned on the flarm and waited for the green light. Next chance, I'll config with the old "6" protocol and see if that works. I used "7" at Paul Remde's suggestion from his website. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New FlarmView Flarm Config Menu? | [email protected] | Soaring | 0 | February 27th 14 05:06 PM |
| Flarm with Firmware 1.20 update | Robert Fidler[_3_] | Soaring | 49 | January 31st 12 03:40 PM |
| Red Box FLARM update question | Martin Gregorie[_5_] | Soaring | 1 | June 11th 11 10:13 PM |
| FLARM UPDATE? | Stephen Michalik | Soaring | 6 | March 20th 11 04:24 PM |
| Help required: Document change control of JAR's | [email protected] | General Aviation | 0 | September 12th 05 02:48 PM |
Hybrid Mode
