![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Nitrogen?
|
#2
|
|||
|
|||
![]()
Nitrogen is a larger molecule, thus it only means the, "normal leak rate" is a bit slower.
Nothing else. Still does not address the original issue, "how do you remove/install" a small tire on a solid rim. Thanks for trying though......;-) RTFQ next time though.......... Thanks.......... |
#3
|
|||
|
|||
![]()
NNTGBOOS. I am using app that seems not to reply to a earlier comment about foam used in tired. Which I would try nitrogen to see if that held up better than air. Maybe then only a **** of nitrogen once a year would be good.
BTW. YLLAA |
#4
|
|||
|
|||
![]()
On Mon, 01 Aug 2016 13:48:30 -0700, Casey wrote:
Which I would try nitrogen to see if that held up better than air. Maybe then only a **** of nitrogen once a year would be good. Nitrogen is slightly lighter than oxygen so, to a first approximation, should leak out a bit faster than air. However because nitrogen, unlike air, doesn't degrade rubber, it may be preferable for this reason. Either air or nitrogen will leak out a lot slower than helium, which diffuses through solids three times faster than air. Only hydrogen has a higher gaseous diffusion rate (154% of helium's rate). However, when you take cost and availability at the airfield into account, putting air into glider tyres may turn out to be the better inflation method. -- martin@ | Martin Gregorie gregorie. | Essex, UK org | |
#5
|
|||
|
|||
![]()
Went to a hardware store solid tire on the tail dolly and Amazon solid tire on the wing wheel years ago. Tired of fixing flats. Yes, they're heavier (a good thing on the wing wheel). They bounce more. But hassle free. Life is short.
Solid tire on the trailer dolly wheel also. Now all I need is run-flat tires for the trailer and a solid tire for the glider main wheel and I'm done. ![]() Oops, there's the glider tail wheel. And the van.... Chip Bearden ASW 24 "JB" |
#6
|
|||
|
|||
![]()
On Monday, August 1, 2016 at 1:33:02 PM UTC-7, Charlie M. (UH & 002 owner/pilot) wrote:
Nitrogen is a larger molecule, thus it only means the, "normal leak rate" is a bit slower. Nothing else. Still does not address the original issue, "how do you remove/install" a small tire on a solid rim. Thanks for trying though......;-) RTFQ next time though.......... Thanks.......... The aviation department at Tractor Supply has a nice wheel for $15 which, with some brass bushings to adapt to the axle diameter and space one side of the wheel to the yoke, is a perfect fit in the tail dolly. Believe it's their part number 3553230. Sorry, nowhere near the trailer or a Tractor Supply at the moment. Jim |
#7
|
|||
|
|||
![]() The aviation department at Tractor Supply has a nice wheel for $15 which, with some brass bushings to adapt to the axle diameter and space one side of the wheel to the yoke, is a perfect fit in the tail dolly. Believe it's their part number 3553230. Sorry, nowhere near the trailer or a Tractor Supply at the moment. Jim The solid tire from Tractor Supply is what I replaced my tire/tube with. Didn't know if anyone had tried Nitrogen is why I mentioned that earlier. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ka-6 E Tail Dolly | [email protected] | Soaring | 0 | November 8th 15 04:26 PM |
Tail dolly for 1-35? | [email protected] | Soaring | 5 | October 22nd 13 11:14 PM |
FS: ASW-24 Tail Dolly | [email protected] | Soaring | 0 | December 26th 06 02:40 PM |
Tail Dolly Tire | Albert Gold | Soaring | 7 | May 19th 05 01:36 PM |
L-23 tail dolly | Mark Zivley | Soaring | 1 | November 27th 04 11:16 AM |