![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I solder them, also, and use a small screw driver or dental pick to aid
in inserting the wire into the connector. There's a definite "click" when the terminal goes home. On 3/7/2017 8:35 PM, Charlie M. (UH & 002 owner/pilot) wrote: I tin the wire, then solder into the connector. If solder blobs out, dress down the diameter of the solder to that of the connector barrel. The last little bit inserting it into the plastic housing can be tough since it's wedged between the plastic and the locking tang. Soldering allows reusing the connector.. Between using them for glider power as well as electric RC, I have done hundreds of connections. -- Dan, 5J |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Saturn IB S-IB Stage Thrust Structure Assembly at Michoud Assembly Facility 6974931.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 02:45 AM |
Saturn IB S-IB Stage Thrust Structure Assembly at Michoud Assembly Facility 6973027.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 02:45 AM |
Saturn IB S-IB Stage Assembly at Michoud Assembly Facility 6973449.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 02:43 AM |
Saturn IB S-IB Stage Assembly at Michoud Assembly Facility 6973447.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 02:43 AM |
Saturn IB S-IB Stage Assembly at Michoud Assembly Facility 6522687.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 02:43 AM |