![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
In article , "Morgans"
writes: Ah Hell Chuck, you missed the point of the question here. Bob Reed I don't think the OP was asking a trick question. While you and I understand the relation between thrust and HP, I do not think the OP has a grasp on it. What was not said, was, "if I use the correct prop to get 2300 RPM at full power, will the 100 HP and 150 HP engine have the same thrust?" On the other hand, I could be reading too much between the lines, and could be completely wrong. If so, "never mind" :-) -- Jim in NC Now that is an entirely different question and the answer is likewise entirely different. I was not reading anything extra into the original question (for a change) and the answer would be no difference. Bob Reed www.kisbuild.r-a-reed-assoc.com (KIS Builders Site) KIS Cruiser in progress...Slow but steady progress.... "Ladies and Gentlemen, take my advice, pull down your pants and Slide on the Ice!" (M.A.S.H. Sidney Freedman) |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stupid super cub question | Robert Loer | Home Built | 9 | November 22nd 03 05:28 PM |
Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 01:51 AM |
question about EZRocket | David O | Home Built | 6 | October 1st 03 06:03 PM |
Question on Pulsejets/Ramjets??? | DarylG1532 | Home Built | 3 | August 16th 03 03:20 AM |
Question - Regarding Canard Pushers... | Tilt | Home Built | 33 | August 10th 03 11:07 AM |