![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
If anyone can provide accurate dimensions (diameter, width, axle size), I would be able to provide wheel sets made out of UHMW plastic. Highly abrasion resistant, easy to machine and not brittle like most plastics.
Contact me. info at mmfabrication dot com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Repainting Wingtip | JB Gunner | Soaring | 11 | November 23rd 17 03:33 PM |
new wingtip design | ND | Soaring | 16 | March 1st 15 02:27 AM |
Glue for wingtip wheels? | R Weien | Soaring | 7 | July 16th 11 01:53 AM |
A wingtip | Glenn[_2_] | Aviation Photos | 5 | September 3rd 10 03:33 PM |
Wingtip Camera | NG[_2_] | Soaring | 14 | April 9th 09 11:38 PM |