|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 31st 18, 02:32 PM
posted to rec.aviation.soaring
|
|||
|
|||
Grob G103 canopy transparencies made in the USA
Good show, Bob...........there is a real need for replacement canopies in the US. Thermo Tec was a good source in the past, but they're out of business.
Ray used a shaker-table that lowered a heated acrylic sheet over a felt covered mold. Fascinating to watch, too bad that business equipment, molds and knowledge couldn't be used. Have you tried to contact them? Wishing you well, JJ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WANTED - Grob 102 Canopy | [email protected] | Soaring | 0 | May 14th 15 05:46 PM |
| Grob Twin II Aft Canopy Plexi | Bill T | Soaring | 0 | August 31st 14 02:37 AM |
| Grob G103 hatch latch | bds | Soaring | 1 | June 15th 10 11:29 AM |
| Grob 102 Astir CS Canopy | GARY BOGGS CFIG | Soaring | 1 | October 3rd 09 06:49 PM |
| Grob canopy gasket source (USA) | John H. Campbell | Soaring | 1 | July 23rd 07 05:52 PM |
Hybrid Mode
