|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
June 15th 18, 05:26 AM
posted to rec.aviation.soaring
|
|||
|
|||
LXNav Remote Stick Installation in a ASW 20B
I have installed several remote stick controls onto LXNav equipment. SZD55, ASW24E, ASG29 and Ventus 2c. Some of these have a trim trigger incorporated and it does not present a problem. I particularly remember the SZD55 had the trim trigger wire going through the column and the wires from the controller just ran to one side and there was never a problem.
Be careful with leaving excess wire inside the stick! I have had two installations were the wires from the LXNav control were bunched up near the top and managed to be trapped and damaged against the top of the stick. I now take the top plate and electronics out from the top of the handle and check the wire routing into the top of the control stick. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| LxNav USB hub? | Jonathan St. Cloud | Soaring | 8 | May 21st 18 04:06 AM |
| Butterfly vario and remote control on the stick | [email protected] | Soaring | 1 | July 17th 17 07:04 PM |
| LS7 control stick diameter and LXNav remote stick | Gianni Isotope | Soaring | 2 | March 15th 17 02:36 PM |
| Help Needed: LXNAV S80 and Remote Stick grip | ZP | Soaring | 18 | January 29th 16 03:19 PM |
| LXNAV V7 | Paul Remde | Soaring | 2 | November 2nd 11 12:31 AM |
Hybrid Mode
