![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On Friday, October 12, 2018 at 6:16:35 PM UTC-7, Richard Pfiffner wrote:
Pictures and process for refinishing a ventus b fuselage. Work in progress pictures and process as work is completed. http://www.craggyaero.com/ventus.htm Richard www.craggyaero.com Jeez Richard the shop floor is shinier than many gelcoat finishes :-) |
#2
|
|||
|
|||
![]()
Brings back bad memories. Have fun and good luck Richard !
|
#3
|
|||
|
|||
![]()
I will guess it was painted/epoxy coated during the fuselage sanding.
Yes, it's shiny. |
#4
|
|||
|
|||
![]()
On Friday, October 12, 2018 at 7:14:55 PM UTC-7, Darryl Ramm wrote:
On Friday, October 12, 2018 at 6:16:35 PM UTC-7, Richard Pfiffner wrote: Pictures and process for refinishing a ventus b fuselage. Work in progress pictures and process as work is completed. http://www.craggyaero.com/ventus.htm Richard www.craggyaero.com Jeez Richard the shop floor is shinier than many gelcoat finishes :-) Darryl, That is water on the floor after much sanding therapy and washing the floor |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
refinishing Ventus 2cm- wing profile | [email protected] | Soaring | 20 | November 6th 11 12:15 AM |
refinishing | Stig Pedersen | Soaring | 1 | November 27th 05 04:50 PM |
refinishing | Stig Pedersen | Soaring | 1 | November 26th 05 09:16 PM |
Second speaker in Ventus 2b/c fuselage | [email protected] | Soaring | 3 | September 14th 05 05:41 PM |
REFINISHING | Ventus B | Soaring | 32 | December 3rd 03 10:14 PM |