![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
My battery analyzer is based on this cheap chinese coulometer:
https://www.ebay.com/itm/DC8-80V-50A...-/252470874308 I use small car light bulb (10-20W) as a load. I connect the thing between charger and batter or load and battery. That way I can measure capacity both ways. It is also super easy to discharge battery to optimum state for winter storage. I like it so much I seriously thought about putting it my glider panel. If it only would support 2 or 3 batteries. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Test results LiFePO4 glider batteries after 6 years | SF | Soaring | 102 | August 9th 18 06:46 PM |
Resetting a Bienno LiFePO4 Battery | OHM Ω http://aviation.derosaweb.net | Soaring | 3 | June 26th 18 09:26 PM |
LiFePO4 battery technolocy | [email protected] | Soaring | 9 | October 17th 12 10:05 PM |
LiFePO4 battery | ASM | Soaring | 4 | December 6th 11 07:00 PM |
Spring Cleaning and Battery Testing | ContestID67[_2_] | Soaring | 34 | March 20th 11 06:49 PM |