![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On Sunday, 2 June 2019 16:20:36 UTC+1, wrote:
My homemade one has a manual tongue jack incorporated...shouldn't cost a tenth of that. Do you have any pictures? I've not got extensive workshop facilities but I'm not averse to a bit of DIY. I don't have any welding equipment (or skills!) so that might be a challenge. |
#2
|
|||
|
|||
![]()
Dear Paul:
I do have a photo, just e-mail me directly. The tongue jack section, sans wheel, is inserted in between the wing cuff and axles. It all breaks down by pulling clevis pins, so the individual sections aren't so heavy. It's steel, which gives it a lower cg, very hard to drop a wing. Almost re-did it aluminium before the light bulb came on! |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Soaring Aids Variometer | Tony Condon[_2_] | Soaring | 4 | July 4th 09 11:24 AM |
Soaring Aids Variometer | Tony Condon[_2_] | Soaring | 0 | July 2nd 09 04:00 PM |
Hearing Aids | Casey Wilson | Piloting | 9 | February 20th 06 01:40 AM |
Yet another case of AIDS | jsmith | Piloting | 12 | March 18th 05 01:20 AM |
MT Props w/Electric Pitch Control | x | Home Built | 6 | April 1st 04 02:44 PM |