|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
June 19th 19, 04:28 PM
posted to rec.aviation.soaring
|
|||
|
|||
FLARM Core boot time?
Time the boot up a couple of times before attempting the update. Average
those times and then add a few seconds and proceed.Â* It should boot up in about the same time every time. On 6/19/2019 9:16 AM, Dave Nadler wrote: Uli - Hold the button down until you see "updating..." on the Butterfly screen. Then wait for it to finish loading new butterfly firmware and/or FLARMnet. Hope that helps, Best Regards, Dave -- Dan, 5J 
|
|
#2
June 19th 19, 04:40 PM
posted to rec.aviation.soaring
|
|||
|
|||
|
FLARM Core boot time?
Do remember to have a Butterfly update file on the USB if you don't want to see "WAITING" until you power off.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SN10b and Flarm core | AS | Soaring | 7 | May 26th 16 04:36 AM |
| Information for all users of Flarm, OEM FLARM supplier and Flarm PowerFlarm | [email protected] | Soaring | 28 | March 12th 16 04:31 AM |
| Mux, 302, Flarm Core, Dell Streak | Blake Seese 9V | Soaring | 5 | April 27th 15 03:06 PM |
| PowerFLARM Core secondary FLARM antenna | [email protected] | Soaring | 27 | October 7th 14 01:53 PM |
| FLARM Core weight | [email protected] | Soaring | 6 | May 11th 13 07:21 PM |
Hybrid Mode
