|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 6th 03, 10:41 PM
|
|||
|
|||
Transponder code switching
What is the proper way to switch transponder codes? The way I have
been taught is to put the transponder in stand by, switch to the new code. Then turn it to mode C I had an instructor tell me to just change it to the new code without turning it to stand by first. Like to hear from controllers as to what they prefer. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VHF & Transponder antenna | Steve | Home Built | 1 | December 6th 04 05:29 PM |
| FS: Narco AT-50A Transponder with ACK Encoder | JR | Home Built | 0 | April 29th 04 12:33 PM |
| Fixing the Transponder with Duct Tape and Aluminum Foil | Ron Wanttaja | Home Built | 45 | March 14th 04 01:18 AM |
| For Jim Weir: Transponder Installation | Ron Wanttaja | Home Built | 11 | February 3rd 04 04:26 PM |
| transponder check? | Russell Duffy | Home Built | 10 | August 15th 03 12:36 AM |
Threaded Mode