|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 16th 04, 02:53 AM
|
|||
|
|||
Vaccuum Pressure Gauge
Now that its cold again, my vacuum pressure gauge is acting up (again). In
the past, when it was cold, it would take a few minutes to come up to the correct reading. Now, it takes about 30 to 40 minutes to come up. All dials are OK, and when the gauge comes up, it reads in the normal range. Any suggestions or good shops??? Thanks! Alex awaddell .a.t. codestrike d-o-t com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Attn: Hydraulic experts - oil pressure relief fix? | MikeremlaP | Home Built | 0 | November 2nd 04 05:49 PM |
| Need gauge help/information | dave | Home Built | 3 | February 17th 04 02:39 AM |
| Manifold pressure gauge problem | Dave Russell | Aerobatics | 3 | January 29th 04 03:46 AM |
| Wanted clever PA32 engineer's thoughts - Gear extention problem on Piper Lance | [email protected] | Owning | 5 | July 22nd 03 12:35 AM |
| Pressure Differential in heat Exchangers | Bruce A. Frank | Home Built | 4 | July 3rd 03 05:18 AM |
Threaded Mode