If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cambridge 302 question
Had my ship refinished and the 302 has had issues since. Replaced the temp probe due to damage and have flown it one time since. For the first 10 minutes the needle was at zero, later moving and matching the LX S100 data for the most part. I have it paired with a ClearNav and at one point the numbers on that we're crazy, as in showing 16,000 feet low on slope, etc. So, although I had already gone through each page of the 302 and checked the settings I did so again post-flight. All were normal and the temperature checked out so I know the probe is good.
My question is relating to numbers on page 10 of the 302, which actually has a number of sub-pages. One page is labeled IAS and shows 83 while on the ground and the next page, labeled ASI, is showing 1690. The manual says it should not show above 1000 while offering no guidance on adjustment, etc. Any information to point me to resolving this issue is appreciated. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question on Cambridge 302/Glide Nav 2 combo | JimF | Soaring | 2 | November 29th 13 12:16 AM |
Cambridge Utility Program Question | Scott Alexander[_2_] | Soaring | 4 | February 9th 10 07:34 PM |
Cambridge 302 Question | [email protected] | Soaring | 15 | April 20th 09 07:46 PM |
Cambridge 303 Display Question | Tim Hanke | Soaring | 1 | April 20th 09 04:13 PM |
Cambridge Fuse Question | Brian Iten | Soaring | 9 | January 4th 05 02:43 PM |