If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
what is this mystery pratt and whitney tool?
Steve Hix wrote:
In article , brian whatcott wrote: Stealth Pilot wrote: .. reminds me of the disassembly of my Auster. armed with a full set of good quality A/F spanners I was horrified to find that not one spanner fitted The entire aircraft had to be disassembled with two adjustable jaw spanners. why the poms used BA I'll never know. Stealth Pilot .er... the BA was an effort at going metric! Then there was BSF, BSWhit BSBike, BSPipe, RAS and several others that I forget. I thought it was bad enough with a Morris Minor I once owned that, depending on what I was working on, required either metric, inch, or Whitworth sockets. Didn't know how lucky I was... well...there's SAE of course, and metric both sure to be found on recent US production. But there has been Unified, ANC, ANF, NatStdPipe and a few others I forget.... Brian W |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Strange 747/Pratt & Whitney project | Ricky | Piloting | 14 | February 1st 09 11:24 PM |
PRATT & WHITNEY PROPOSES F-22A ENGINE VARIANT FOR LONG-RANGE STRIKE | Mike[_7_] | Naval Aviation | 0 | May 30th 07 02:44 PM |
Was the Pratt & Whitney Double Wasp the best engine of WW II? | Dave Kearton | Aviation Photos | 18 | January 12th 07 07:20 PM |
Question Pratt & Whitney Tool ... | joseph | Restoration | 0 | October 1st 05 02:57 PM |
World War Two Era U.S. Radial Engines (Curtiss and Pratt&Whitney) | Lincoln Brown | Military Aviation | 10 | February 13th 04 04:30 AM |