|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 3rd 08, 08:37 AM
posted to rec.aviation.soaring
|
|||
|
|||
Ventus 2cxM Solo 2625 01 EGT Installation
Has anyone fitted an EGT (exhaust gas temperature) to a Ventus 2526 01 solo
engine? I'm looking for information on what to purchase and how to install it. Unfortunately the Schempp-Hirth or Solo are unable to help. This is very disappointing. DG offer an EGT option on their Solo 2625 01 engine however they only offer for purchase the EGT probes. I can only assume that the EGT display is integrated into their EMS (Engine Management System). Regards Chris Woolley Australia 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WX-950 installation | Kyprianos Biris | Owning | 5 | October 23rd 07 01:37 PM |
| Wanted Ventus CM (solo type 23-50C) Muffler. | [email protected] | Soaring | 0 | May 6th 07 07:06 PM |
| SOLO 2625-02 engine drawings | Maciek | Soaring | 2 | April 5th 07 01:15 PM |
| US ELT Installation | mhr | Soaring | 57 | December 31st 05 07:39 PM |
| EGT installation | Andre | Home Built | 4 | August 27th 03 08:33 AM |
Threaded Mode