|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 12th 03, 01:48 PM
|
|||
|
|||
Clup prop
I'm looking for a club prop I can use to break in/test an engine. I
could use a regular prop I suppose, but the engine will be on a test stand and I'd rather have something with a reduced diameter for safety. The engine will be producing around 180 to 190 hp and I'd like to be able to run it up to full power/rpm for extended periods. Maximum prop rpm will be 2400. The prop hub has a standard bolt pattern. Any ideas? Suggestions? Thanks, Corky Scott 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Right prop, wrong prop? Wood prop, metal prop? | Gus Rasch | Aerobatics | 1 | February 14th 08 10:18 PM |
| Wooden Prop | minot piper e | Home Built | 1 | October 26th 03 11:39 PM |
| website for Warp Drive prop pls | John Freeman | Home Built | 4 | October 14th 03 01:39 PM |
| want variable pitch prop | Ray Toews | Home Built | 5 | October 7th 03 09:59 PM |
| Metal Prop vs. Wood Prop | Larry Smith | Home Built | 21 | September 26th 03 07:45 PM |
Threaded Mode