If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Welding question #1
I'm at my welding table practicing welding with a new torch, and I've
found myself burning thru the metal. I've been correcting the error by filling in the metal with filler and continuing with the exercise. Can I do the same to correct a "run away hole" on real work? - Mike |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Welding question - | Michael Horowitz | Restoration | 11 | September 7th 06 03:52 PM |
Welding question 2 | Bill Daniels | Home Built | 11 | June 10th 06 01:48 AM |
Welding question: 43-13-1B, Fig.4-43 | Mike | Restoration | 0 | May 15th 06 02:36 PM |
Welding question | Mike | Restoration | 4 | February 20th 06 02:23 PM |
Welding question | Michael Horowitz | Home Built | 1 | October 13th 05 09:53 PM |