|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 31st 04, 03:38 AM
|
|||
|
|||
Shutting down engine Question
Perhaps this doesn't matter much for a non-turbocharged engine,
but an instructor says that it is best to idle the engine at 1,000 RPM for a few moments before Mixtu Idle Cut-Off at that RPM to shut down. The POH says throttle full aft, then mixture cut-off to shut down. Which is best? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My Engine Fire!! | [email protected] | Piloting | 21 | April 2nd 04 05:02 PM |
| Starting Engine Question (O-320, Warrior) | Lisa | Piloting | 13 | April 1st 04 06:45 AM |
| My Engine Fire!! | [email protected] | Owning | 1 | March 31st 04 01:41 PM |
| engine overhaul & autopilot question | CriticalMass | Owning | 8 | February 13th 04 06:11 PM |
| Corky's engine choice | Corky Scott | Home Built | 39 | August 8th 03 04:29 AM |
Threaded Mode