|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 3rd 04, 04:39 AM
|
|||
|
|||
GNS430 Installation
Anyone install a GNS430 to interface with a KI-209A CDI, Navaid Device
autopilot and JPI EDM700 (let's see what else...)?? I'm removing my GX50 and Icom for this newer system. But if the GNS430 cannot be set for a enroute sensitivity of +-1 mn (vice 5 nm), as my GX50 can, then it's a show stopper. Wayne 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Photos of damage to J3 Cub propeller after new engine mount installation | [email protected] | Home Built | 0 | August 9th 04 09:32 PM |
| Photos of damage to J3 Cub propeller after new engine mount installation | [email protected] | Home Built | 0 | August 9th 04 09:31 PM |
| Camloc Installation Tools | jls | Home Built | 13 | May 7th 04 05:11 AM |
| For Jim Weir: Transponder Installation | Ron Wanttaja | Home Built | 11 | February 3rd 04 03:26 PM |
| EGT installation | Andre | Home Built | 4 | August 27th 03 08:33 AM |
Linear Mode
