|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 26th 06, 01:36 AM
posted to rec.aviation.soaring
|
|||
|
|||
SNAV-LNAV low memory-battery voltage message?
I had my SNAV send the low memory-battery message and
shut down and restart while flying. I dutifully replaced the battery and still get the same message...I checked the replacement and it is 3.4 volts on the amp-meter. The manual says the message is only generated if power less then 2.2 volts. Any ideas? I will send this question to Cambridge as well. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| So I invested my US$6°°.....GUESS WHAT!!!... less than ten days later, I received money | [email protected] | Owning | 1 | January 16th 05 07:48 AM |
| High Voltage | Jim Rosinski | Piloting | 7 | October 16th 04 11:48 PM |
| SNav / LNav Question | Dan Pitman | Soaring | 4 | September 2nd 04 09:40 PM |
| For Keith Willshaw... | robert arndt | Military Aviation | 253 | July 6th 04 06:18 AM |
| Autorotation ? R22 for the Experts | Eric D | Rotorcraft | 22 | March 5th 04 07:11 AM |
Linear Mode
