|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
March 8th 04, 04:09 AM
|
|||
|
|||
Source for Aluminum Bar 1 Inch thick 4 Inches Wide
Try Shapiro Supply . com They are in St. Louis. Good prices Jon
"Spar" wrote in message ... Would appreciate hearing from anyone who has information on who to contact to purchase Aluminium Bar 1 inch thick 4 inches wide 60 inches long. Thanks Spar 
|
|
#2
March 9th 04, 05:23 AM
|
|||
|
|||
|
In article ,
"Jon Ritter" wrote: Try Shapiro Supply . com They are in St. Louis. Good prices Jon "Spar" wrote in message ... Would appreciate hearing from anyone who has information on who to contact to purchase Aluminium Bar 1 inch thick 4 inches wide 60 inches long. Thanks Spar There are lots of surplus metals places that can supply it. What alloy do you want?
|
|
#3
March 9th 04, 02:40 PM
|
|||
|
|||
|
"Spar" wrote in message ... Would appreciate hearing from anyone who has information on who to contact to purchase Aluminium Bar 1 inch thick 4 inches wide 60 inches long. Thanks Spar Try The Yard Store at www.surplusaircrafttools.com
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NEED: Source for Aluminum Bar 1 Inch thick 4 Inches Wide | [email protected] | Home Built | 4 | March 16th 04 11:11 PM |
| NEED: Source for Aluminum Bar 1 Inch thick 4 Inches Wide | Craig | Aviation Marketplace | 3 | March 16th 04 11:11 PM |
| NEED: Source for 2 pcs Aluminium Plate 1 Inch x 4 inch 5 foot length | Spar | Home Built | 4 | March 12th 04 12:31 AM |
| Source for Aluminum Bar 1 Inch thick 4 Inches Wide | Jon Ritter | Home Built | 2 | March 9th 04 02:40 PM |
| NEED: Source for Aluminum Bar 1 Inch thick 4 Inches Wide | [email protected] | Aviation Marketplace | 0 | March 7th 04 05:06 PM |
Hybrid Mode
