|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 27th 07, 02:54 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Laminating an aileron spar
I need to add about 1/4" strip to the edge of my newly purchased
spruce aileron spar, 'cause I need to add a bevel. The spar is 3" wide so the proposed strip is only a fraction of the area. Can anyone see a problem if I used fir instead of spruce for this strip? Fir is more easily available locally - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cub aileron hinges | minot piper e | Aviation Marketplace | 0 | October 23rd 04 04:51 AM |
| FA: Maule M5 Aileron | BFC | Aviation Marketplace | 0 | September 24th 04 05:31 PM |
| Need aileron | OSKI 3 | Owning | 0 | September 15th 03 08:46 PM |
| Need aileron | OSKI 3 | Home Built | 0 | September 15th 03 08:45 PM |
| Need Aileron | OSKI 3 | Aviation Marketplace | 0 | September 15th 03 08:45 PM |
Threaded Mode