|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
December 18th 11, 10:40 PM
posted to rec.aviation.soaring
|
|||
|
|||
Worn Cobra rear-door hinges (both pin and hole)
Hi Steve - What do you think of the Cobra (aluminum)
pin into a bushing: http://www.mcmaster.com/#5448T18 I was planning to do as you did, but it would be much quicker to just add a bushing and replace the pins. Thanks in advance, Best Regards, Dave "YO electric" 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Worm Hole no Need for Black Hole | Michael Baldwin, Bruce | Products | 2 | May 8th 07 12:04 PM |
| Beat up / worn out Arrow valuation | Chuck | Owning | 20 | May 12th 05 12:01 AM |
| worn injector? | [email protected] | Owning | 4 | February 17th 05 07:16 AM |
| T-hangar's bi-fold door: Convert to a motorized opening door? | Peter R. | Piloting | 16 | August 21st 04 02:06 AM |
| 172 door hinges: right way, wrong way, my way??? | Mike Z. | Owning | 4 | April 6th 04 09:07 PM |
Threaded Mode