|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
December 24th 03, 01:02 PM
|
|||
|
|||
On Wed, 24 Dec 2003, Peter Dohm wrote:
Therefore, my most recent thinking is leave the engine completely stock, including all harmonic balancing and damping components; and supply it with an offset reduction drive. Just my 2 cents. I agree Peter, I also used the stock 5spd transmission as a psru, but did use a lighter flywheel. Over five years flying, almost 400 hours, I love it! George Graham RX-7 Powered Graham-EZ, N4449E Homepage http://bfn.org/~ca266 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 1 | January 2nd 04 10:02 PM |
| Aircraft per hour cost | Fitzair4 | Home Built | 0 | December 1st 03 03:15 PM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | October 2nd 03 04:07 AM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 4 | August 7th 03 06:12 AM |
| Homebuilt Aircraft Frequently-Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | July 4th 03 05:50 PM |
Threaded Mode