|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#8
January 10th 04, 10:40 PM
|
|||
|
|||
Dave wrote: I would want to drill 4 sheet metal screws into those sections of panel. Would a 337 be required for that? You can drill holes in any non-structural part without a 337. George Patterson Great discoveries are not announced with "Eureka!". What's usually said is "Hummmmm... That's interesting...." 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Boeing Boondoggle | Larry Dighera | Military Aviation | 77 | September 15th 04 03:39 AM |
| Panel Lights - Need Help | Barnyard BOb - | Home Built | 2 | May 29th 04 08:51 PM |
| Panel Overlay repair | Jeff P | Home Built | 2 | January 26th 04 06:23 PM |
Threaded Mode