|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
February 4th 04, 04:26 AM
|
|||
|
|||
Bob Chilcoat wrote ...
I scored some of the above sheet. I need to fabricate an approach plate holder for my GPS yoke mount. Any idea if T6 will bend without cracking? If so, what minimum bending radius should I aim for to avoid cracks? AC43.13-1B, Table 4-6 doesn't list 0.050, but it straddles it: 6061-T6 0.032 ½t-1½t 6061-T6 0.064 1t-2t Daniel 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode