![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
|
|||
|
|||
|
On Thu, 08 Jul 2004 16:05:19 +0000, Nathan Young wrote:
On Wed, 07 Jul 2004 12:59:05 GMT, Nathan Young wrote: My Cherokee is in the paint shop, due out in a few weeks. Looking for suggestions on maintaining a new Imron finish... Of course, I will solicit input from the paintshop as well. The plane is hangared, and only sits outside when on trips, so I figure that is a good start. Many people do not recommend washing/waxing new paint for several months (to allow full curing). Is this required? I fly IFR. Need I be concerned about flying into rain or keeping the plane out of rain until it is 'fully cured'? How about taking bugs off the leading edge? New question. How long is cure time? They should be able to tell you. It will vary from paint to paint. The chemicals that they add to the paint prior to spraying, may also make a difference, as will humidity and temp. Make sure they tell you and then add a week or so to it. Whatever they tell you will be an educated guess, nothing more. Better to be safe than sorry. Greg |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| VA Health Care | Steve Mellenthin | Military Aviation | 0 | August 19th 04 06:45 PM |
| Good Paint Remover? | Marco Leon | Owning | 2 | June 22nd 04 08:58 PM |
| The State of the Union, Health care and more lies from the President | George Z. Bush | Military Aviation | 15 | June 14th 04 06:56 AM |
| Radar Absorbing Paint | robert arndt | Military Aviation | 2 | December 2nd 03 06:09 PM |
| Choice of Paint for use over Copper foil Antennas | Charlie Precourt | Home Built | 1 | December 2nd 03 03:51 AM |