|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
September 17th 04, 08:46 PM
|
|||
|
|||
Well thanks guys, I am off to my local aircraft store [Lowe's] to get the
special allen wrench recommended. I shall be careful to work in the "rough" at the side of the fairway so that I do not lose the springs :-) Thanks Roy "Roy Page" wrote in message ink.net... I want to remove the KMA20, Dual HX170B's and KT76 from their trays so that I can easily clean up all the knobs faceplates etc. What special tools do I need to remove them ? And ... Where can I purchase ? Thanks in advance for the good response I know I will get. Roy Page 28291 Misty Morning Lane Beloit, OH 44609 330 537 8677 http://www.g4dyr.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode