|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
November 28th 04, 10:56 PM
|
|||
|
|||
On Sun, 28 Nov 2004 15:52:04 GMT, "Mike V." wrote:
"Nathan Young" wrote in message .. . On Fri, 26 Nov 2004 21:32:53 GMT, "Steven Barnes" wrote: A corner of the wing step "tread" is peeling up on my Cherokee 180. Is there a particular glue or epoxy to use/stay away from? I can just see a big chemical hole being eaten right through my wing... ;-) I just had my Cherokee painted this summer. They used a single-piece wing walk. It had the adhesive already installed - just had to clean the surface, peel, and apply. ... and then you end up with peeling problems on the wing walk. The stick on wing walks are crap, they tend to peel. They should be painted on... Time will tell. 4 months and all is well  
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode